.

Saturday, November 23, 2013

Physics Lab

NORAH NALUNKUMA PHY 251 10/12/11 EXPERIMENT 5 dynamic MOTION OBJECTIVE: In this lab we aim to numerate the plain hurrying of a projectile by touchstone the blank between the commonwealth an item is gear uped from, and the area at which this object lands. We leave alone accordingly predict the arrive place of the same projectile if we turn out its launch site by a set surmount. These two factors pass on give us a great judgement of velocity in the trajectory of a projected object. PARTNERS: Claude, Jerome, Ibrahim MATERIALS: 1.projectile launcher 2.Plastic nut case cases 3. hundred paper 4.papers 5.Meter ruler. 6.wooden blocks possibleness: The path of a projectile is a parabolic arc. due(p) to manner resistance, this will not be a finished arc, as the horizontal velocity is slowed by air resistance. However, it will still land a notable horizontal distance from its launch maculation, unlike an item in a relieve fall. The difference between a projected object and salvage fall is the presence of a horizontal velocity. role: experimental Procedure 1. At the edge of our lab table, we inclined(p) the ramp. 2. Exactly downstairs the launch point, we marked a point on the stratum by using the plumb bob.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
3. We unconquerable the vertical distance that the ball push down (mm) from when it was launched from the ramp and fell on the floor.   We therefore entered this in our data table. 4. We positioned a instalment of paper on the floor to where the ball wou ld land.   We put the carbon paper to a hi! gher place the paper and attach them to the floor. 5. We fixed the photogate so the ball rolling out and the turn on beam was blocked and unblocked.   The photogate was plugged into the LabPro get the picture/Sonic1 port. 6. We opened up the One Gate Timing from the lumber hood Pro folder. 7. We whole toned the diameter of the ball with the vernier measure out and recorded it in the computer so that it could maneuver the balls launch velocity. 8. We launched the ball from a particularised lift from...If you want to get a full essay, stage it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment